To synchronise the control kit of the SIOUX 33770, CIES 33512 and POLARIS 33346 models, the steps to follow are as follows:
Instructions
- After installation and complete assembly, turn off the power to the fan for at least 10 seconds.
- Insert the battery into the remote control.
- Reconnect the fan to the power supply. The receiver will be active for synchronisation only for 30 seconds after switching the power back on.
- Press and hold the "FAN ON/OFF" button until a continuous beep sounds for about 2 seconds. This beep normally takes about 6 seconds to occur.
- Execute a command and the fan will obey. In case the fan does not follow the given commands, repeat the operation starting from the power failure mentioned in step 1.
More than one fan
If you have more than one fan in the same room, and you want them to operate independently, you will have to follow the same steps as above. The process will have to be carried out individually and independently with a control for each fan.
Remember that you must also turn off the power to each fan independently. A general or common cut-off is not useful as it may lead to error and both fans would try to synchronise with the same control. The aim is that the operation of one fan does not affect the operation of other fans.
If you want to synchronise and control more than one fan with the same remote control, you only need to carry out the same process with the same remote control for each of the fans to be controlled. In this way all the fans will operate at the same time.
SMART FAN connection
Watch this video if you want to know how to connect the ceiling fan with SMART FAN technology to any device.
SMART FAN technology allows you to:
- Operate the ceiling fan
- Program the on/off switch
- Create customised scenes for each room
- Regulate the speeds
- Control the light