To synchronise this control kit, the steps to follow are as follows:
- After installation and complete assembly, turn off the power to the fan for at least 10 seconds.
- Insert the batteries into the remote control.
- Reconnect the fan to the power supply. The receiver will be active for synchronisation only for 30 seconds after the power is turned back on.
- Press and hold the "POWER" button until a continuous beep sounds for about 2 seconds. Normally, this beep takes about 6 seconds to occur.
- Execute a command and the fan will obey.
In case the fan does not follow the given commands, repeat the operation starting from the power failure mentioned in step 1.
More than one FAN
If you have more than one fan in the same room, and you want them to work independently, you will have to follow the same steps as mentioned above. The process will have to be carried out individually and independently with a control for each fan. Remember that you must also turn off the power to each fan independently. A general or common cut-off is not useful as it may lead to error and both fans would try to synchronise with the same control. The aim is that the operation of one fan does not affect the operation of other fans.
If you want to synchronise and control several FANS with the same remote control, you only need to carry out the same process with the same transmitter control for each of the fans to be controlled. In this way all the fans will operate at the same time.